@waako wrote:
I’ve got an emonTH v2 with an external DS18B20, and I was looking to connect up the Flukso water probe sensor.
I’ve looked through the emonTH wiki page about adding a pulse sensor.
However, the Flukso sensor cable only has a red and black wire, and I’m conscious that the DS18B20 is already using the GND terminal pin.
i rarely get round to doing any electronics, so have to relearn everything each time, but is it possible to have both external temperature sensor and water probe wired in at same time?I’ve also got issues with range, where EmonHub is only getting data from EmonTH intermittently, due to thick stone walls and I’m getting the metal shelving. However, the EmonTX v3 is only a couple of meters from EmonTH and thanks to it’s big antenna has no problem getting data to EmonHub.
I thought I read somewhere there was a way of using EmonTX for example as a relay for the EmonTH signal, but I got lost in the details of the old forum post comments. Would this be possible?
I assume that the Flukso water probe can work with EmonCMS as it was mentionned in this thread https://openenergymonitor.org/emon/node/11754, and I have the exact meter from the flukso shop page.
Has anyone else had any luck/experience doing this?
Many thanks
Posts: 15
Participants: 4
